It finally got too cold for shorts here in Phoenix, so joggers were a natural progression. I love that they're stretchy and allow for plenty of running, crawling, and climbing.
Edison's hoodie in the photos above, if you're curious, is from A Quiver Full
. Use the code "JESUS" for 20% off!
This project has been sitting on my Pinterest board for ages, and I finally did it! If my photos and directions below don't make sense, check out the original tutorial I followed here
. These really do take half an hour, or less! I made two pairs during one nap-time.
You will need:
- An adult tee shirt. I used an old shirt from Loft.
- 1/2 wide elastic for the waistband.
- Paper for your pattern.
- A sewing machine and thread, scissors, etc.
Step 1: Make your pattern. On a large piece of paper, mark the waistband of the pants, and then the crotch, and then the ends of the legs on your paper, and fill in the sides. Add an inch to the top, because this will be folded over to make your waistband. Add a half inch around the edge, for your seam. Your patter should look a little more square than the pair of pants you're tracing.
Step Two: Cut out your pieces. Place your tee shirt on a flat surface, making sure the hem lines up. Then pin your pattern to the tee, lining up the legs with the bottom of the shirt (I didn't get the left leg lined up perfectly, but ideally, they should both line up). Then cut through both layers of the tee.
Step Three: Turn the pieces so the right sides are together. Then, sew a quarter inch seam around the pant legs.
Step 4: Fold over your waistband, and sew down the edge, leaving a gap of a couple inches for putting in the elastic.
Step Five: Going off of the existing pair of pants you used for your pattern, measure your elastic and cut it to that size. Push a safety pin through one end, and then feed it through the hole you left in the waistband, and pull all the way through.
Once you have the elastic all the way through, you'll need to sew the ends of the elastic together. fold them over each other, and sew a few lines up and down to tack them together. Above, I've done it on a second pair of pants. Getting the elastic under the sewing machine is probably the most tricky part of this whole thing.
Step Six: Once the elastic is back inside, sew the gap closed, and turn right side out.
Tada! Happy Christmas crafting! And enjoy some more photos of Edison modeling :)
Labels: Baby, Christmas, craft, create, easy, Edison